Chapter 2
Installing the System
Cabling and Powering On the Server
91
Step 10. A screen similar to Figure 2-35 will display allowing verification of the settings.
Figure 2-35The ls Command Screen
To return to the MP Main menu, enter ma.
To exit the MP, enter x at the MP Main Menu.
Accessing the Management Processor via a Web Browser
Web browser access is an embedded feature of the management processor (MP). The Web browser enables
access to the server via the LAN port on the core I/O card. MP configuration must be done from an ASCII
console.
NOTE The MP has a separate LAN port from the system LAN port. It requires a separate LAN drop,
IP address, and networking information from that of the port used by HP-UX.
Before starting this procedure, gather the following information:
• IP address for the MP LAN
• Subnet mask
• Gateway address
• Host name (this is used when messages are logged or printed)
To configure the LAN port for a Web browser, perform the following steps:
Step 1. Connect to the MP using a serial connection.
Step 2. Configure the MP LAN. Refer to “Configuring LAN Information for the MP”.
Step 3. Type CM to enter the Command Menu.
To Next Page
Loading...
Need help?
General