HP PROCURVE 2910AL Configuration Guide

IPv6 Management Features
TFTP File Transfers Over IPv6
TFTP File Transfers Over IPv6
TFTP File Transfers over IPv6
You can use TFTP copy commands over IPv6 to upload, or download files to
and from a physically connected device or a remote TFTP server, including:
■ Switch software
■ Software images
■ Switch configurations
■ ACL command files
■ Diagnostic data (crash data, crash log, and event log)
For complete information on how to configure TFTP file transfers between
the switch and a TFTP server or other host device on the network, refer to the
“File Transfers” appendix in the Management and Configuration Guide for
your switch.
To upload and/or download files to the switch using TFTP in an IPv6 network,
you must:
1. Enable TFTP for IPv6 on the switch (see “Enabling TFTP for IPv6” on
page 5-16).
2. Enter a TFTP copy command with the IPv6 address of a TFTP server in
the command syntax (see “Using TFTP to Copy Files over IPv6” on page 5-
17).
3. (Optional) To enable auto-TFTP operation, enter the auto-tftp command
(see “Using Auto-TFTP for IPv6” on page 5-19).
5-15

HP PROCURVE 2910AL Specifications

General

Brand	HP
Model	PROCURVE 2910AL
Category	Switch
Language	English