Fabric OS 6.2 administrator guide 295
In the following example, the list is empty:
switch:admin> msconfigure
0 Done
1 Display the access list
2 Add member based on its Port/Node WWN
3 Delete member based on its Port/Node WWN
select : (0..3) [1] 1
MS Access list is empty.
0 Done
1 Display the access list
2 Add member based on its Port/Node WWN
3 Delete member based on its Port/Node WWN
select : (0..3) [1] 0
done ...
switch:admin>
Adding a member to the ACL
1. Connect to the switch and log in using an account assigned to the admin role.
2. Enter the msConfigure command.
The command becomes interactive.
3. At the select prompt, enter 2 to add a member based on its port/node WWN.
4. At the Port/Node WWN prompt, enter the WWN of the host to be added to the ACL.
5. At the select prompt, enter 1 to display the access list so you can verify that the WWN you entered
was added to the ACL.
6. After verifying that the WWN was added correctly, enter 0 at the prompt to end the session.
7. At the Update the FLASH? prompt, enter y.
To Next Page
Loading...
Need help?
General