HP StorageWorks 4/8 - SAN Switch User Manual

306 iSCSI gateway service
connection redirection for specific slots, and the all option may be used to disable connection
redirection for all slots.
The following example disables connection redirection for ports on a blade located in slot 9.
switch:admin> iscsiswcfg --disableconn -s 9
The operation completed successfully
Displaying connection redirection status
1. Connect to the switch and log in.
2. Enter the iscsiSwCfg --showconn command with the -s all option to display the current status
of connection redirection.
The following is an example.
switch:admin> iscsiswcfg --showconn -s all
Number of records found: 2
Slot ICR Status
10 enabled
1 disabled
switch:admin>
Supported iSCSI initiators
Table 73 lists iSCSI initiators supported by the iSCSI gateway service.
Checklist for configuring iSCSI
After you install the HP StorageWorks B-Series iSCSI Director Blade in the HP StorageWorks 4/256 SAN
Director (see the Brocade FC4-16IP Hardware Reference Manual), you configure the iSCSI gateway
Table 73 Supported iSCSI initiators
iSCSI initiator driver versions
Windows
• MS iSCSI initiator 2.02
• MS iSCSI initiator 2.03
• MS iSCSI initiator 2.04
Linux
• RH EL 4 default initiator
• 2.6.10 - 4.0.2 iSCSI initiator (SourceForge,Net initiator)
• 2.4.20 - 3.6.2 iSCSI initiator (SourceForge,Net initiator)
•SUSE 9
•SUSE 10
Solaris
• iSCSI is built-in with the 5.11 with the latest Solaris Express release
AIX
• iSCSI is built-in in the 5.3 ML4
HP-UX
• 11i v1 - B.11.23.03e
• 11 iv2 - B.11.23.03e
NIC/TOE cards
iSCSI HBAs
• Alacritech SES2002XT
• Qlogic 4050c

HP StorageWorks 4/8 - SAN Switch Specifications

General

Brand	HP
Model	StorageWorks 4/8 - SAN Switch
Category	Switch
Language	English