98 Managing user accounts
When the command succeeds, the event log indicates that a server configuration is changed.
Configuring local authentication as backup
It is useful to enable local authentication so that the switch can take over authentication locally if the
RADIUS or LDAP servers fail to respond because of power outage or network problems. To enable or
disable local authentication, enter the following command for RADIUS:
switch:admin> aaaconfig --authspec "radius;local" --backup
or, for LDAP:
switch:admin> aaaconfig --authspec "ldap;local" --backup
For details about this command, see Table 13 on page 84.
When local authentication is enabled and the RADIUS or LDAP servers fail to respond, you can log in to
the default switch accounts (admin and user) or any user-defined account.
When the command succeeds, the event log indicates that local database authentication is disabled or
enabled.
server Enter either the name or IP address of the server whose position is to be changed.
to_position Enter the position number to which the server is to be moved.
To Next Page
Loading...
Need help?
General