450 Administering ISL trunking
4. Show the TA port configuration (ports still disabled):
switch:admin> porttrunkarea --show enabled
Slot Port Type State Master TI DI
-------------------------------------------
10 13 -- -- -- 125 125
10 14 -- -- -- 125 126
-------------------------------------------
5. Enable ports 13 and 14:
switch:admin> portenable 10/13
switch:admin> portenable 10/14
6. Show the TA port configuration:
switch:admin> porttrunkarea --show enabled
Slot Port Type State Master TI DI
-------------------------------------------
10 13 F-port Master 10/13 125 125
10 14 F-port Slave 10/13 125 126
Enabling F_Port trunking
The following example shows how to enable F_Port trunking on a stand-alone switch using ports 36–39.
1. Disable ports 36–39 by entering the portDisable port command for each port to be included in the
TA.
2. Enable Trunk Area for ports 36–39 with area number 37:
switch:admin> porttrunkarea --enable 36–39 -area 37
Trunk area 37 enabled for ports 36, 37, 38 and 39.
3. Re-enable ports 36–39 by issuing portEnable port for each port in the TA.
To Next Page
Loading...
Need help?
General