offers VxVM, which includes DMP. HP supplies HDLM. All these products provide multipath
configuration management, FCAs I/O load balancing, and automatic failover support, however
their level of configuration possibilities and FCAs support differs.
• For instructions on STMS, Storage Multipathing, or VxVM, see the manufacturers' manuals.
SNMP configuration
The XP7 family of disk arrays support standard SNMP for remotely managing arrays. The SNMP
agent on the SVP performs error-reporting operations requested by the SNMP manager. SNMP
properties are usually set from the SVP but they can also be set remotely using the XP7 Remote
Web Console or XP7 Command View Advanced Edition Suite Software. For specific procedures,
see the applicable user guide.
Figure 1 SNMP configuration
RAID Manager command devices
The following applies to OpenVMS, HP-UX, IBM AIX, Linux, Solaris, VMware, and Windows.
• HP XP7 RAID Manager Software manages HP XP7 Business Copy Software or HP XP7
Continuous Access Synchronous Software operations from a host server. To use RAID Manager,
you must designate at least one LDEV as a command device. This can be done with the XP7
Remote Web Console or XP7Command View Advanced Edition Suite Software. For information
about how to designate a command device, see the applicable user guide.
• Creating scripts to configure all devices at once could save you considerable time.
The following applies to OpenVMS.
When creating a command device, HP recommends creating a LUN 0 device of 35 megabytes
(the smallest allowed). This allows you to use host-based RAID management tools available from
HP, and will allow HP support to perform some additional diagnostics.
NOTE: Storage assigned to the LUN 0 device is not accessible to OpenVMS.
SNMP configuration 11
To Next Page
Loading...
Need help?
General
