16 TUNING THE ENGINE 83
F00095-10
–
Position half-shells
, mount and tighten screws
.
Guideline
Screw, throttle grip M6 5 Nm (3.7 lbf ft)
–
Slide on sleeve
and check the throttle grip for ease of movement.
Finishing work
– Check the play in the throttle cable. ( p. 81)
16.4 Changing the mapping
Info
The desired engine characteristic can be activated via the MAP button on the combination switch.
The setting most recently selected is activated again when restarting.
The traction control can also be activated in each mapping using the TC button.
The mapping can also be changed during the ride.
H01180-10
Activating STANDARD mapping:
– Press button MAP until LED1 lights up.
Guideline
Engine speed < 4,000 rpm
STANDARD – balanced response
H01180-11
Activating ADVANCED mapping:
– Press button MAP until LED2 lights up.
Guideline
Engine speed < 4,000 rpm
ADVANCED – direct response
16.5 Adjusting the idle speed
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may result in unconsciousness and death.
– Always make sure there is sufficient ventilation when running the engine.
– Use an effective exhaust extraction system when starting or running the engine in an enclosed space.
Warning
Danger of accidents The engine may go out spontaneously if the idle speed is set too low.
– Set the idle speed to the specified value. (Your authorized Husqvarna Motorcycles workshop will be glad to help.)
To Next Page
Loading...
Need help?
General
