25 STANDARDS
152
JASO T903 MA2
Different technical development directions required a separate specification for motorcycles – the
JASO T903 MA2 standard.
Earlier, engine oils from the automobile industry were used for motorcycles because there was no separate
motorcycle specification.
Whereas long service intervals are demanded for automobile engines, the focus for motorcycle engines is on
high performance at high engine speeds.
In most motorcycle engines, the transmission and clutch are lubricated with the same oil.
The JASO T903 MA2 standard meets these special requirements.
SAE
The SAE viscosity classes were defined by the Society of Automotive Engineers and are used for classifying
oils according to their viscosity. The viscosity describes only one property of oil and says nothing about quality.
To Next Page
Loading...
Need help?
General
