IBM 5100 User Manual

(
(
DCP2 Menu
MDI (MAP Diagnostic Integration)
Loading:
1. Select
the MDI section number from the DCP2 menu.
2. Enter
the MDI section number.
3. Press the EXECUTE key.
This procedure loads and
automatically runs the MDI.
To stop the MDI and return to the MDI options, press the ATTN key.
The following message might appear if
the MDI halts:
ENTER Y OR N (B,
0, T)
Y
= Yes}
N = No
B
= Back:
0= Option:
T = Trace:
I
MDI ran OK.
"-- Return to MAP
or
press ATTN
key twice and
select
the next
MDI:
Refers
to an answer to a specific question on the display
screen. Enter
the appropriate answer and press the
EXECUTE key.
You can
enter B or BXX and press the EXECUTE key.
XX is the number of steps you want to back up in the
trace table.
You can
enter 0 and press the EXECUTE key to display
the MDI options.
You can
enter T and press the EXECUTE key to display
the s~eps that were executed along with the decision
(Y
or N) that was displayed. To obtain a c~py of the
trace table, press the HO.LD key, press and hold the
CMD key, and press the; key.
I I
Intervention required. Read
the display and take the
appropriate action.
RESTART
5100 Diagnostics Overview 3·31

IBM 5100 Specifications

General

Brand	IBM
Model	5100
Category	Laptop
Language	English