3-32
DCP2
I
MOl
Options
Loading:
1. Select the
MOl
section from the DCP2 menu.
2. Enter the
MOl
section number:
3. Press the
# key.
4. Enter the letter 0 (option).
5.
Press the EXECUTE key.
The
MOl
option table
is
now
on
the
display screen.
Note: The
II
key
will
tab
to
the
next
entry instruction.
MODE:
STEP
RUN
Halts
at
each step and waits until the EXECUTE key
is
pressed
to
continue.
You can change the decision
of
a step by keying
in
Y,
N,
B,
0,
or T.
(default selection) Runs
MOl
automatically and halts when a question
must be answered.
NEXT STEP
NO:
Enter the next step number
to
be executed. (If you are using the
loop on path option, you must enter the
stop
number here.)
LOOP ON:
STEP
PATH
MOl
Allows looping on a specified
next
step number.
Allows looping on a path specified by the path start number and path
stop
number. The last step
in
the trace must be answered yes.
Allows looping a complete
MOl
section
in
step and run mode.
UNTI
L:(Use
with loop on option)
Blank Loops until the
CMD
and
AnN
keys are pressed (used with loop
YES
NO
DIFFERENT
on step).
Loops until a yes decision
is
obtained (used with loop on step).
Loops
unti.1
a no decision
is
obtained (used with loop on step).
- .
Loops until a decision different from the decision established
by the trace
is
obtained (used with loop on path
or
MOl).
PATH START NO: Defines the path start num,ber when loop on path
is
selected.
PATH STOP NO: Defines the path stop number when loop on path
is
selected.
I '\
To Next Page
Loading...
Need help?
General