Notices XIII
Canadian Department of Communications Compliance
Statement
This equipment does not exceed Class B limits per radio noise emissions for
digital apparatus, set out in the Radio Interference Regulation of the Canadian
Department of Communications.
Canadian Department of Communications
Certification Label
Notice: The Canadian Department of Communications label identifies
certified equipment. This certification means that the equipment
meets certain telecommunications network protective, operational
and safety requirements. The Department does not guarantee the
equipment will operate to the user's satisfaction. Before installing this
equipment, users should ensure that it is permissible to be connected
to the facilities of the local telecommunications company. The
equipment must also be installed using an acceptable method of
connection. In some cases, the company's inside wiring associated
with a single line individual service may be extended by means of a
certified connector assembly (telephone extension cord). The
customer should be aware that compliance with the above conditions
may not prevent degradation of service in some situations. Repairs to
certified equipment should be made by an authorized Canadian
maintenance facility designated by the supplier. Any repairs or
alterations made by the user to this equipment, or equipment
malfunctions, may give the telecommunications company cause to
request the user to disconnect the equipment.
Users should ensure for their own protection that the electrical ground
connections of the power utility, telephone lines and internal water pipe
system, if present, are connected together. This precaution may be
particularly important in rural areas.
Attention: Users should not attempt to make such connections themselves,
but should contact the appropriate electric inspection authority, or
electrician, as appropriate.
To Next Page
Loading...
Need help?
General