2-26
CD-ROM Drive
Note: The CD-ROM indicator on the front panel lights up while data
is being read from the disc; flashes during seek operation.
001 - START
− Insert the bootable Diagnostic diskette (with CD-ROM drive driver
installed) into the diskette drive.
− Ensure there is no CD in the CD-ROM drive.
− Select Interactive Tests menu.
− Select and execute CD-ROM Test.
002 - DO YOU SEE A MESSAGE “NO CD-ROM DRIVE OR
MSCDEX DEVICE DRIVER INSTALLED.”? (YES, READ
AHEAD. NO, GO TO 004 )
− Exit the diagnostic program and power off the system.
− Check and ensure CD-ROM drive power, audio and data cables
are not damaged and are connected properly.
− Check and ensure CD-ROM drive driver if load correctly.
003 - HAS THE SAME MESSAGE OCCURED MORE THAN ONCE?
(YES, GO TO STEP 009. NO, GO TO STEP 001)
004 - DO THE TEST OF OPEN/CLOSE TRAY BY DIAGNOSTIC
PROGRAM AND BY DEPRESSING CD-ROM DRIVE BUTTON
WORK? (YES, READ AHEAD. NO, GO TO STEP 007.)
− Load a data CD into the CD-ROM drive and try to read its content
by typing DIR in DOS prompt.
005 - DOES THE CD DISC CAN BE READ? (YES, GO TO STEP
008. NO, READ AHEAD.)
− Try with a know-good CD and try to read it again.
007 - DOES THE CD STILL CANNOT BE READ? (YES, READ
AHEAD. NO, GO TO STEP 009.)
− Replace system board
− End
To Next Page
Loading...
Need help?
General