Check Procedures 2-37
Diagnostics for Factory-Installed Riser Card,
or Audio-I/O Card Not Supported by
Diagnostics Program
Note: While performing this check, you may need to enter and exit
Microsoft Windows 95 several times. When instructed to select an
icon or button, double-click on the item with the mouse.
For more information about using Microsoft Windows 95, see
the user's guide provided with the computer.
If an operating system other than Microsoft Windows 95 is
installed, program screens and icons may differ from these
instructions.
This Diagnostics test is intended to be used only with factory-
installed adapter cards.
001 - START
− Remove the Bootable Diagnostics Diskette.
− Power-off the system unit and wait 10 seconds.
− Power-on the system unit.
002 - IS A POST ERROR CODE AND MESSAGE DISPLAYED?
(YES, GO TO STEP 018. NO, READ AHEAD.)
003 - ARE ANY MESSAGES OR ERROR CODES DISPLAYED
AFTER POST COMPLETES BUT BEFORE MICROSOFT
WINDOWS 95 STARTS? (YES, GO TO STEP 007. NO, GO
TO STEP 004)
Note: If POST does not complete, answer this question "No."
004 -
− Power-off the system unit.
− Disconnect the riser card and any adapter card’s cables or
connectors from the system unit.
Notes: When removing adapter cards, be careful not to change
any jumper or switch settings on the card.
− Power-on the system unit.
To Next Page
Loading...
Need help?
General