2-36
− If a factory-installed drive device or adapter card is not listed in the
Tech Support Form, go to "Diagnostics for Factory-Installed Riser
Card, or Audio-I/O Card Not Supported by Diagnostics Program "
on page 2-37.
− End
005 -
− Select Diagnostics from the Main Menu.
− Select and execute All Tests from the Diagnostics Menu.
006 - DOES THE TEST FINISH WITHOUT FAILURE? (YES, READ
AHEAD. NO, GO TO STEP 007)
− The Diagnostic \ All Test did not detect a failure. If the system still
displays a failure:
• Check all adapter card jumper settings.
• Check all adapter card switch settings.
• Check all adapter card cables and connectors for proper
installation.
• Make sure all of the above are set correctly and show the
correct voltages and continuity. Replace any defective
cables or adapter cards. See "Power Supply" on page 2-32,
"System Board Layout” on page 5-2.
− Run the Diagnostic \ All Test again.
• If an error or other symptom is displayed, go to "Index of
Symptoms, Messages, Error Codes, or Beeps" on page 2-7.
• If no error can be detected or the symptom is intermittent, go
to "Undetermined Problem" on page 2-45.
− End.
007 -
− If the last test stops and you cannot continue, first make sure all
switches, power connectors, cables, and jumpers are set correctly
and show the correct voltages and continuity.
− Make note of any messages, error codes, beeps, or new
symptoms. Go to “Index of Symptoms, Messages, Error Codes, or
Beeps” on page 2-7.
− End
To Next Page
Loading...
Need help?
General