General Information 1-33
Operating Requirements
All machines require two power input: one on the system unit and one on the
display.
The system units come with a voltage selector switch, allowing selection of
voltage of either 110Vac or 220Vac. This switch must be in the 220 Vac
position when the machine is plugged into a 220 Vac electrical outlet.
If the display was shipped with the model, its required power supply input is
voltage auto-sensing type which doesn’t need to set any switch.
When the system unit is powered off for 10 seconds or more and then
powered on, the power supply generates a "power good" signal that resets the
system logic.
A Note About Energy Saver Monitors
• Monitors rated as "Energy Saver" models use less than 15 watts when
operating in the energy-saving mode or when the system unit is powered
off.
• To extend monitor life, the monitor should be powered off at the end of
each day.
Special Tools
The following special tools are required to service this system:
• Wrap plug, P/N 72X8546
To Next Page
Loading...
Need help?
General