Check Procedures 2-35
Device Presence by Diagnostics Program Test
001 - START
− Insert the Bootable Diagnostics Diskette into the diskette drive.
− Power-off the system unit.
− Power-on the system unit, and check for the following responses:
1. One short beep after POST completed.
2. Diagnostic program main menu screen.
002 - DO ANY POST MESSAGES, ERROR CODES, BEEPS, OR
SYMPTOMS APPEAR? (YES, READ AHEAD. NO, GO TO
STEP 003)
− Go to "Index of Symptoms, Messages, Error Codes, or Beeps" on
page 2-7.
003 -
− Select Utility on the menu.
− Select and execute Tech Support Form on the menu to generate
a hardware configuration list.
− Compare the Tech Support Form screen with the actual devices
installed in the system unit.
Note: If necessary, remove the cover and visually compare the
devices installed in the system unit to those shown in the
Tech Support Form.
004 - DOES THE TECH SUPPORT FORM CORRECTLY IDENTIFY
THE DEVICES INSTALLED IN THE SYSTEM UNIT? (YES,
READ AHEAD. NO, GO TO STEP 005)
− The Tech Support Form shows only those devices supported by
the Diagnostics Diskette and only factory-installed devices for the
model you are servicing.
− If a device is missing from the list and is not factory installed, refer
to the service manual provided for that device. (Refer to the
Appendix B, "Model/Monitor Configurations and FRU Part
Numbers" to determine the factory-installed devices in the model
you are servicing.)
To Next Page
Need help?
General
