2-6
007 -
The Hardware Configuration Report shows only those devices
supported by the Diagnostics Diskette and only factory-installed
devices for the model you are servicing.
If a device is missing from the list and is not factory installed, refer to
the service manual provided for that device. (Refer to the Appendix B,
"Model/Monitor Configurations and FRU Part Numbers" to determine
the factory-installed devices in the model you are servicing.)
If a factory-installed drive device or adapter card is not listed in the
Hardware Configuration Report, go to "Diagnostics for Factory-
Installed Riser Card, or Audio-I/O Card Not Supported by Diagnostics
Program" on page 2-37.
008 - DOES THE DIAGNOSTICS\ALL TEST FINISH WITHOUT ERROR
CODES? (YES, READ AHEAD. NO, GO TO STEP 009.)
− If the DIAGNOSTICS\ALL TEST did not detect a failure. If the
system still displays a failure:
• Check all adapter card jumper settings.
• Check all adapter card switch settings.
• Check all adapter card cables and connectors for proper
installation.
• Make sure all of the above are set correctly and show the
correct voltages and continuity. Replace any defective
cables or adapter cards. See "Power Supply" on page 2-32,
"System Board Layout” on page 5-2.
− Run the DIAGNOSTICS\ALL TEST again.
− If an error or other symptom is displayed, go to "Index of
Symptoms, Messages, Error Codes, or Beeps" on page 2-7.
− If no error can be detected or the symptom is intermittent, go to
"Undetermined Problem" on page 2-45.
− End
009 -
− If the last test stops and you cannot continue, first make sure all
switches, power connectors, cables, and jumpers are set correctly
and show the correct voltages and continuity.
− Make note of any messages, error codes, beeps, or new
symptoms. Go to "Index of Symptoms, Messages, Error Codes, or
Beeps" on page 2-7.
To Next Page
Loading...
Need help?
General