Error Codes or Messages
Note: In the charts,
x
can be any character.
Message Action
I9990301
I9990302
I9990305
(Incorrect connection of
the hard disk drive might
cause these error codes
to appear.)
Your computer can't find the startup drive. Do the following:
1. Turn off the computer.
2. Press and hold F1; then turn on the computer to start Easy-Setup. Hold F1
until the Easy-Setup menu appears.
3. Select the Start up icon.
4. Select Power-On or Network. If you are unable to set the startup
sequence, have the computer serviced.
5. Check the devices in the startup sequence box. Is the default drive listed in
the startup sequence box?
Yes Exit this window, and turn off the computer.
No Select the Reset icon.
6. Is an operating system installed?
Yes Go to step 8.
No Install the operating system in your computer.
7. After you install the operating system, turn off the computer.
8. Turn on the computer.
If the same message appears, have the computer serviced.
I99
xxxxx
(except the
above I999030x errors)
Have the computer serviced.
| 111
| (docking station error)
| If you are using a port replicator or a docking station, disconnect it; then
| reconnect it.
| If you still have a problem, refer to the manual shipped with your port replicator
| or docking station.
16
x
or 17
x
(undefined date or
configuration error)
Follow the instructions on the screen.
174
(device configuration
error)
Make sure that the hard disk drive is connected correctly. If the problem
persists, have the computer serviced.
Chapter 7. Solving Computer Problems 103
To Next Page
Loading...
Need help?
General
