Installing Software for Windows NT
This section describes the installation procedures for Windows NT
Workstation Version 4.0 and its device drivers.
Overall Procedure
1
Have the Windows NT installation package in hand.
2
Back up your software and personal data files on the hard disk.
3
Create the installation diskettes of the device drivers using the
Diskette Factory program preloaded on the hard disk. You
need to create at least the following device driver diskettes:
4
Install Windows NT and the device drivers.
Device Driver Diskette Name
ThinkPad Configuration
program
Utility Diskette for Windows NT
Display driver Video Features Diskette III for Windows NT
PC Card support software CardWizard for Windows NT
Audio device driver Audio Features Diskette for Windows NT
ThinkPad Modem software ThinkPad Modem for Windows NT
Infrared device driver Infrared Features Diskette II
TrackPoint driver TrackPoint Driver Diskette for Windows
95/Windows NT
IDE driver IDE Driver Diskette
Installing Microsoft Windows NT
Before installing Windows NT, do the following:
Read the Windows NT installation guide.
If you plan to use OS/2 Warp with Windows NT, you need to use
the OS/2 Warp Boot Manager. For more information, read
Installing IBM OS/2.
You can install Windows NT using the internal CD-ROM drive or an
externally attached CD-ROM drive through the port replicator.
However, if your computer does not have a CD-ROM drive, or if a
Chapter 8. Installing Software 151
To Next Page
Loading...
Need help?
General
