10
Select “PS/2 TrackPoint” from the list to the right.
11
Click on OK.
12
Click on Close in the “Mouse Properties” window.
13
Restart your computer to make the new settings effective.
Installing the CD-ROM Device Driver for Windows 95
This section describes how to disable the unnecessary DOS and
Windows CD-ROM device drivers.
If you installed Windows 95 on a blank hard disk drive without
DOS and Windows,
Windows 95 has automatically installed a
generic ATAPI CD-ROM device driver for your ThinkPad's
CD-ROM drive. You do not need to do the following procedure.
If you installed Windows 95 in a computer on which DOS and
Windows had been already installed,
you need to disable the
DOS and Windows CD-ROM device drivers to use the correct
Windows 95 generic ATAPI CD-ROM device driver.
To disable the DOS and Windows CD-ROM device drivers:
1
Start Windows 95 and go to the MS-DOS command prompt.
2
Open the CONFIG.SYS file with your text editor; then find the
following line:
DEVICE=C:\xxxxxx\IBMTPCD.SYS /R
Note
xxxxxx
is the subdirectory where you have installed the
CD-ROM device driver. The default subdirectory for
C:\
xxxxxx
is C:\CDROM.
If you cannot find the line, quit the file and go to step 4.
3
Comment out the line to change it as follows:
REM DEVICE=C:\xxxxxx\IBMTPCD.SYS /R
If the line is already commented out, quit the file and go to the
next step.
Chapter 8. Installing Software 149
To Next Page
Loading...
Need help?
General
