IBM ThinkPad 600 User Manual

13 Restart your computer to make the new settings effective.
Installing the IDE Driver for Windows NT
Install the ThinkPad PIIX4 IDE driver as follows:
|
1 Start Windows NT and log on with the user ID authorized as an
| administrator.
2 Insert the IDE Driver Diskette into the diskette drive.
3 Click on Start.
4 Click on Settings and Control Panel.
5 Double-click on SCSI Adapters.
6 Click on the Drivers tab.
7 If Intel PIIX PCI Bus Master IDE Controller is listed, remove
it.
8 If IDE CD-ROM (Atapi 1.2)/Dual Channel PCI IDE is listed,
remove it.
9 Click on Add.
10 Click on Have Disk...
11 Click on OK after confirming that the installation path is correct
(usually it points to A:\).
12 Select ThinkPad PIIX4 IDE Driver; then click on OK.
13 If you are prompted to restart your computer, remove the
diskette from the diskette drive and click on Yes.
Chapter 8. Installing Software 161

IBM ThinkPad 600 Specifications

General

Processor	Intel Pentium II
Graphics	Neomagic MagicGraph128XD
Operating System	Windows 95, Windows 98, or Windows NT 4.0
Resolution	800 x 600
Battery	Lithium-Ion
Optical Drive	Optional external CD-ROM drive
Ports	Serial, Parallel, VGA
Network	10/100 Ethernet
Clock Speed	233 MHz to 300 MHz
Display	12.1-inch TFT