Icom IC-R6 User Manual

29
6
SCAN OPERATION
New2001
q Push [V/M] to select the VFO mode.
• Push [BAND] to select a desired frequency band.
w Set the squelch level.
e Hold down [SCAN](MODE) for 1 second to enter the scan
type selection mode.
r Rotate [DIAL] to select a desired scanning type.
• Select “ALL” for full scan, “BAND” for band scan, “P-LINK x” for
programmed link scan (x= 0 to 9), “PROGxx” for programmed
scan (xx= 0 to 24; only programmed scan edge numbers are
displayed).
[DIAL]
Selectable between
“0” to “24” if programmed (p. 30)
Selectable between
“0” to “9” if programmed (p. 53)
• Full scan
• Band scan
• Program link scan
• Program scan
Rotate
Hold down
for 1 sec.
t To start the scan, push [SCAN](MODE).
• The scan pauses when a signal is received.
• Rotate [DIAL] to change the scanning direction. This also
resumes scanning.
• Push [SCAN](MODE) again to stop the scan.
During full/band scan During programmed/
link program scan
NOTE: Instead of doing steps e to t, while holding
down [SCAN](MODE), rotate [DIAL] to select a desired
scan type. In this case, the scan starts after releasing
[SCAN](MODE).
✔ CONVENIENT!
The memorised skip frequencies can be skipped or scanned
during a VFO scan.
➥ In the VFO mode, hold down [FUNC], then push
[ ](V/M) to set the skip scan setting ON or OFF.
(default: ON)
■ Full/band/programmed link/programmed scan
The scan link name or scan name can be displayed
instead of “P-LINK x” for program link scan (x= 0 to 9),
“PROGxx” for programmed scan (xx= 0 to 24) when scan
link name or scan name is programmed.
Scan link name or scan name is not displayed during scan.

Icom IC-R6 Specifications

General

Product color	Black
Channels quantity	1550 channels
Supported radio bands	AM, FM
Battery type	AA
Number of batteries supported	2
Impedance	16 Ω
Frequency range	0.1 - 1309.995 MHz
Product type	Portable CB radio
Housing material	-

Weight and Dimensions

Depth	29.8 mm
Width	58 mm
Height	86 mm
Weight	200 g