63
10
OTHER FUNCTIONS
New2001 New2001
■ Partial reset
If you want to initialize the operating settings (VFO fre-
quency, VFO settings, Set mode contents) without clearing
the memory contents, a partial reset of the receiver can be
done.
➥ While holding down [FUNC] and [TS], turn the power ON
to partially reset the receiver.
■ All reset
The function display may occasionally display erroneous
information (e.g. when first applying power). This may be
caused externally by static electricity or by other factors.
If this problem occurs, turn power OFF. After waiting a few
seconds, turn power ON again. If the problem persists, per-
form the following procedure.
• Partial resetting is also available. See the details to the left.
IMPORTANT:
Resetting the receiver CLEARS all memory information
and initializes all values in the receiver.
The preprogrammed (depending on the receiver version)
memory information is also cleared.
➥ While holding down [FUNC] and [V/M], turn the power
ON to reset the CPU.
To Next Page
Need help?
General
Weight and Dimensions
