32
6
SCAN OPERATION
New2001
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
■ Programming other contents
The programmed scan can store the scanning step, receive
mode and attenuator settings.
q Push [V/M] to select the memory mode.
w Rotate [DIAL] to select a desired scan edge channel.
e Hold down [S.MW](V/M) for 1 second to enter the select
memory write mode.
• 1 short and 1 long beep sounds.
• The “ ” icon and memory channel number blink.
r While holding down [MODE], rotate [DIAL] to select the
“TS,” “MODE” or “ATT” item when programming the tuning
step, the receive mode or the attenuator setting.
• The item can also be selected by repeatedly pushing [MODE].
t Rotate [DIAL] to select a desired option.
Or, select the “-- -- -- --” display when erasing the contents“-- -- -- --” display when erasing the contents-- -- -- --” display when erasing the contents” display when erasing the contents display when erasing the contents
from the option.
• If “-- -- -- --” is selected in this step, the program scan uses the“-- -- -- --” is selected in this step, the program scan uses the-- -- -- --” is selected in this step, the program scan uses the” is selected in this step, the program scan uses the is selected in this step, the program scan uses the
VFO settings.
y Hold down [S.MW](V/M) for 1 second to program the
name and exit the programming mode.
• 3 beeps sound.
During the full/band scan:
The selected tuning step, received mode and attenuator set-
tings in each frequency band are used.
During the programmed/programmed link scan:
The programmed tuning step, received mode and attenuator
settings in each programmed scan edge are used.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
