Jacobsen Eclipse 322 Repair Manual

4-92 4222983 Second Edition
ELECTRICAL
4
Figure 4-74
5. Place the key switch in the on position and observe
the +12 volt power in LED (5).
Is the +12 volt power in LED illuminated?
YES The +12 volt power input is good. Proceed to
the next step.
NO Check 12 volt start batter y, cables, and
connections. Repair or replace as needed.
6. Place the key switch in the off position. Open the
MCU access panel, place the key switch in the on
position and observe the glow plug relay output
LED (2).
Does the glow plug relay output LED illuminate
for approximately five seconds?
YES MCU glow plug output is good. Proceed to
the next step.
NO MCU is faulty. Replace as needed.
7. Place the key switch in the start position and observe
the start relay output LED (1).
Does the start relay output LED illuminate while
the key switch is in the start position?
YES MCU start relay output is good. Proceed to
the next step.
NO MCU is faulty. Replace as needed.
8. Place the key switch in the off position to reset the
controller. Place the key switch in the start position
and observe the fuel pull solenoid output LED (4) and
the fuel hold solenoid output LED (3).
Does the fuel pull solenoid LED illuminate for
approximately two seconds before going out and
illuminating the fuel hold solenoid output LED?
YES The MCU fuel pull and hold solenoid outputs
are good. Proceed to the next step.
NO MCU is faulty. Replace as needed.
9. With the key switch in the start position, measure
voltage at the fuel solenoid.
Does the multimeter display 12VDC?
YES The MCU to fuel solenoid har ness and
connections are good. Test the fuel shutoff
solenoid, replace as needed.
NO The MCU to fuel solenoid harness is faulty.
Test wire harness and connections.
10. With the key switch in the start position, measure
voltage at the starter solenoid.
Does the multimeter display 12VDC?
YES The starter solenoid harness is good. Test
stater solenoid, replace as necessary.
NO Check PDU to starter solenoid harness. If
har ness tests good, the start relay is faulty.
Replace the PDU.
Start Circuit–Gasoline Engine
Symptom: Machine Will Not Start
IMPORTANT
System requires a minimum of 43VDC in order for the
start circuit to operate properly. Verify system
voltage before performing the following procedure.
1. Turn the key to the run position. Enter the
maintenance mode. Toggle the LCD to the switch
status screen.
Figure 4-75
SPARE 12V DGTL LO IN
GENSET STATUS
INPUTS
OUTPUTS
+48VDC POWER IN
+12VDC FUEL SOL PWR IN
+12VDC POWER IN
FUEL PULL SOLENOID
FUEL HOLD SOLENOID/
ANTI-FIRE SOLENOID
GLOW PLUG RELAY
START RELAY
TRACTION CONTACTOR
HEAD LIGHT
TCU FAN OUTPUT
SPARE OUTPUT 2
SILENT MODE OUTPUT
13
14
1
2
3
4
5
6
7
8
9
10
11
12
TN2832
1
2
3
4
5
SWITCH STATUS
000 0001 001
TN2831
1

Jacobsen Eclipse 322 Specifications

General

Brand	Jacobsen
Model	Eclipse 322
Category	Lawn Mower
Language	English