3-38 4222983 Second Edition
GENSET AND BATTERY PACK
3
Figure 3-70
20. Support battery pack tray (31) with a suitable lifting
device.
21. Remove two nuts (27), lock washers (28), flat
washers (29), and screws (30).
22. Repeat step 21 for other side of machine.
23. Remove battery pack tray (31).
NOTICE
Installation Note
Install battery pack, battery pack tray, and batter y filling
system by reversing the order of removal.
Buffer Battery Pack and Buffer
Battery Pack Tray
Removal and Installation
See Figures 3-71 and 3-72.
WARNING
WARNING
1. Park the mower safely. (See “Park Mower Safely” on
page 1-6.)
2. Swing the center cutting unit out from the machine
and lock into position.
Figure 3-71
NOTE
Label all wires before disconnecting to ensure correct
installation.
Never place used batteries in the garbage.
Dispose of used batteries in accordance with all
applicable regulations.
TN2800
27 28 29 30
31
Be sure that the key switch is off, all electrical
accessories are turned off, and the 12-volt and
48-volt power connectors are disconnected
before starting work on vehicle.
• Battery posts, terminals, and related
accessories contain lead and lead
compounds. Wash your hands after handling.
• Always wear eye protection when servicing
battery.
6
TN2449
7
54
8
3
2
1 2
1
2
1 1 2
6543
To Next Page
Loading...
Need help?
General
