GENSET AND BATTERY PACK
4222983 Second Edition 3-37
3
NOTE
Label all wires before disconnecting to ensure correct
installation.
WARNING
4. Disconnect the negative (–) 48-volt connector cable
(2) and negative (–) battery charger cable (10).
5. Disconnect the positive (+) 48-volt connector cable
(1) and positive (+) battery charger cable (11).
6. Disconnect battery cables (7, 8, and 9) from each
upper battery negative (–) battery post.
7. Disconnect battery cables (4, 5, and 7) from each
upper battery positive (+) battery post.
Figure 3-67
8. Remove four nuts (14), flat washers (15), lock
washers (16), and J-bolts (17).
9. Remove battery hold-down carrier (18).
10. Remove the four upper batteries.
11. Remove twelve hoses (12) and sixteen battery filling
system plugs (13) from the upper batteries. Cap
batteries to prevent leakage and contamination.
12. Remove upper tray mat (19).
Figure 3-68
13. Remove screw (21), lock washer (22), flat washer
(23), nut (24), and battery bracket (20).
Figure 3-69
NOTE
Direction of arrow indicates front of machine.
14. Disconnect battery cables (4 and 5) from the two 8V
lower batteries (25).
15. Remove boots from battery cables (4 and 5) and
route cables through grommet at front of battery tray.
16. Disconnect battery cables (8 and 9) from lower
batteries.
17. Remove boots from battery cables (8 and 9) and
route cables through grommet at rear of battery tray.
18. Remove the two lower batteries.
19. Remove battery filling system (26) from lower
batteries. Cap batteries to prevent leakage and
contamination.
Always disconnect the negative terminal first and
positive terminal last. Connect positive terminal
first and negative terminal last. Use care when
testing live circuits to prevent arcing. Arcing
could result in death or serious injury.
171615
18
TN2803
14
19
12
13
TN2315
22
20
23 2421
TN2803
TN2801
5
9 8
4
25
26
To Next Page
Loading...
Need help?
General
