17
18
THE MOTOR ON/OFF SWITCH
(See )
The ON/OFF Motor Trigger
Switch is a non-latching type. It is
ergonomically positioned on the
inside of the Cutting Head ‘D’ handle.
1) Press the switch to start the motor.
2) Release the switch to turn off the
motor.
BASIC CHOP CUTTING
This type of cut is used mainly for
cutting small or narrow section
material. The Cutting Head is gently
pushed down to cut through the
workpiece.
The Sliding Carriage should be
locked in its rearmost position.
(See )
1) Slide the Cutting Head to the rear
as far as it will go.
2) Tighten the slide lock screw. (See
3) Place the the workpiece on the
table and against the fence and
secure with clamp(s) as appropriate.
4) Grasp the saw handle.
5) Turn the motor on and allow the
saw blade to reach full speed.
6) Operate the lower guard locking/
release lever to release the Cutting
Head. (See )
7) Lower the Cutting Handle
downwards and cut through the
workpiece.
16
17
18
19
To Next Page
Loading...
Need help?
General
