CLEARING JAMMED MATERIAL
1) Turn mitre saw “OFF” by releasing
the trigger switch.
2) Allow the blade to come to a
complete halt.
3) Unplug the mitre saw from the
mains supply.
4) Carefully remove any jammed
material from the machine.
5) Check the condition and operation
of the safety guard.
6) Check for any other damage to any
part of the machine e.g. the blade.
7) Have any damaged parts replaced
by a competent technician and a
safety inspection carried out before
using the machine again.
CUTTING CROWN MOULDING
Your JCB Sliding Mitre Saw is
suited to the difcult task of cutting
crown moulding. To t properly,
crown moulding must be compound
mitred with extreme accuracy. The
two surfaces on a piece of crown
moulding that t at against the
ceiling and wall are at angles that,
when added together, equal exactly
90°.
33.9
0
CROWN MOULDING BEVEL
STOP
A positive stop set at 33.9
0
to the Left
Hand is available when the Crown
Moulding Pin is deployed. (See )
28
To Next Page
Loading...
Need help?
General
