8) Allow the speed of the blade to
do the work, there is no need to
apply undue pressure to the Cutting
Handle.
9) When the cut has been completed,
release the ON/OFF trigger switch.
10) Allow the blade to come to a
complete stop.
11) Allow the Cutting Head to rise
to its upper position, with the lower
blade guard completely covering the
blade teeth, and the Cutting Head
locked in the upper position, before
releasing the Cutting Handle.
12) Remove the workpiece
BASIC SLIDE CUTTING
This saw is equipped with a Sliding
Carriage system.
Loosening the slide lock screw
will release the slide and allow the
Cutting Head to move forwards and
backwards. (See )
The saw blade is lowered into the
workpiece and then pushed to the
rear of the machine to complete a
cut. This type of cut can be used for
cutting wide pieces.
1) Position the workpiece on the table
and against the fence and secure
with clamp(s) as appropriate.
2) Loosen the slide lock screw.
3) Grasp the Cutting Handle and pull
the Cutting Head forward until the
arbor (centre of saw blade) is over the
front edge of the workpiece. (See )
4) Operate the ON/OFF motor trigger
20
21
To Next Page
Loading...
Need help?
General
