NOTE: The Bevel Angle Locking
Screw has a spring loaded lever.
(See ) This enables the lever to be
repositioned on the locking screw.
Repositioning may be necessary
to allow the screw to be tightened
sufciently to lock the Cutting Head
in the required position.
1) Loosen the Bevel Lock Handle
2) Tilt the Cutting Head to the desired
angle. A protractor guide is provided
behind the Bevel Lock Handle to aid
setting.
3) Ensure the handle is tightened
securely when the required angle has
been achieved.
COMPOUND CUTTING (See )
A compound cut is a combination of
a mitre and bevel cut.
1) Select the required mitre angle as
previously described in BASIC Mitre
CUTTING.
2) Select the required bevel angle as
previously described In BASIC BEVEL
CUTTING.
3) Ensure the tightness of all
adjustment/locking screws before
making a cut.
CUTTING BOWED MATERIAL
Before cutting any workpiece, check
to see if it is bowed. If it is bowed the
workpiece must be positioned and
cut as shown. (See )
Do not position the workpiece
incorrectly or cut the workpiece
without the support of the fence.
25
26
27
To Next Page
Loading...
Need help?
General
