MAINTENANCE
Note: Any maintenance must be carried out with the machine switched off and
disconnected from the mains/battery power supply.
Check that all safety features and guards operating correctly on a regular basis.
Only use this machine if all guards/safety features are fully operational.
All motor bearings in this machine are lubricated for life. No further lubrication is
required.
Use a clean, slightly damp cloth to clean the plastic parts of the machine.
Do not use solvents or similar products which could damage the plastic parts.
WARNING: Do not attempt to clean by inserting pointed objects through openings
in the machines casings etc. The machines air vents should be cleaned using
compressed dry air.
Excessive sparking may indicate the presence of dirt in the motor or worn out
carbon brushes. If this is suspected have the machine serviced and the brushes
replaced by a qualied technician
Table Inserts
A two piece table insert is tted to this machine. If either side is damaged or worn,
both parts must be replaced. Replacement inserts (sold in handed pairs) are
available from Evolution Power Tools.
To replace the table inserts:
• Remove the 3 or 4 cross-head screws that secure one of the inserts to
the rotary table.
• Lift the insert from the table.
• Remove any debris that may have accumulated under the insert.
• Fit the replacement insert, and replace the three xing screws.
• Repeat the process for the other side.
• Check that all 6 or 8 xing screws are tightened securely, and that both
inserts are lying ush and level within the table.
To Next Page
Loading...
Need help?
General
