ADVICE ON CARRYING
YOUR MITRE SAW
1. Although compact, this saw is
heavy. To reduce the risk of back
injury, get competent help whenever
you have to lift the saw.
2. To reduce the risk of back injury,
hold the tool close to your body
when lifting. Bending your knees so
you can lift with your legs, not your
back. Lift by using the handhold
areas at each side of the machines
base.
3. Never carry the mitre saw by the
power cord or the trigger grip of
the handle. Carrying the tool by the
power cord could cause damage to
the insulation or the wire connections
resulting in electric shock or re.
4. Before moving the saw tighten
the slide lock knob to guard
against sudden movement.
WARNING: Do not use the
blade guard as a
‘lifting point’.
The power cord must be removed
from the power supply before
attempting to move the machine.
• Lock down the head using the
head locking pin.
• Move the Cutting Head to its
outermost position and lock in
place by tightening the slide lock
screw.
• Loosen the mitre angle lock
knob. Pull up the mitre angle
positive locking lever and rotate
the table to either of its maximum
settings.
• Lock the table in position using
the locking knob.
• Use the two carry handle
cut-outs machined into either
side of the machine base, to
transport the machine.
Place the saw on a secure stationary
work surface and check the saw over
carefully. Check particularly the
operation of all the machines safety
features before attempting to operate
the machine.
To Next Page
Loading...
Need help?
General
