CHECKING AND SETTING OF
PRECISION ANGLES
WARNING: Only attempt
these procedures with the
machine disconnected from the
power supply.
NOTE: When checking angular
alignments the Cutting Head should
be lowered and locked in the down
position with the latching pin fully
located in its socket.
0
0
Bevel Stop Adjustment
1. Ensure that the Cutting Head is
upright against its stop and the Bevel
Pointer is indicating ‘0
0
’ on the scale.
(See )
2. Place a combination square (not
supplied) on the mitre table with one
edge against the table and the other
edge against the blade. (See )
3. If the blade is not 90
0
square with
the mitre table adjustment is required.
4. Loosen the Bevel Lock Handle and
tilt the Cutting Head to the left.
5. Loosen the locknut on the Bevel
Angle Adjustment Screw. (See )
6. Use an Hex Key to adjust
the screw in or out to adjust the
inclination of the blade.
7. Return the Cutting Head to its
upright position and recheck angular
alignment against the combination
square.
30
31
29
To Next Page
Loading...
Need help?
General
