ENVIRONMENTAL PROTECTION
Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist. Check with your local authorities or
retailer for recycling advice.
PLUG REPLACEMENT (UK & IRELAND ONLY)
If you need to replace the tted plug then follow the instructions below.
IMPORTANT:
The wires in the mains lead tted to this product are coloured in accordance with the
following code:
Brown: Live (L)
Blue: Neutral (N)
THIS PRODUCT IS DOUBLE INSULATED AND THEREFORE DOES NOT REQUIRE A
CONNECTION TO EARTH.
• THE 3 PIN PLUG MUST COMPLY TO BS1363/A.
• THE FUSE MUST COMPLY TO BS1362.
If for any reason the 13 amp moulded plug tted to this product requires replacing,
the replacement must be wired in accordance with the following instructions:
• Connect the Blue wire to the terminal marked Neutral (N).
• Connect the Brown wire to the terminal marked Live (L).
Ensure that the outer insulation is gripped by the cord grip and that the wires are not
trapped when replacing the plug cover.
A 13 amp (BS1362) fuse must be tted in the plug.
Do not connect any wire to the earth pin MARKED E on the 3 pin plug.
NOTE: If a moulded plug is tted and has to be removed, take great care in disposing
of the plug and severed cable. It must be destroyed to prevent it ever again engaging
into a socket.
30
ERBAUER 216MM (8”) SLIDING MITRE SAW
ENVIRONMENTAL PROTECTION
Waste electrical products should not be
disposed of with household waste.
Please recycle where facilities exist.
Check with your Local Authority or
retailer for recycling advice.
PLUG REPLACEMENT
The fuse in the main plug of your power tool
should always be replaced with one of
identical rating.
Check the voltage given on your power tool
matches the supply voltage.
The power tool is supplied with a fi tted plug,
however if you should need to fi t a new plug
follows the instruction below.
IMPORTANT
The wire in the mains lead are coloured in
accordance with the following code:
Blue ---Neutral
Brown ---Live
The wire that is coloured blue must be
connected to the terminal that is marked with
the letter N. The wire that is coloured brown
must be connected to the terminal that is
marked with the letter L. A 13AMP (BS1363
or BS1363/A) plug must be used and a 5 AMP
fuse must be fi tted.
A 13AMP (BS1363 or BS1363/A) plug must be
used and a 5 AMP fuse must be fi tted.
To Next Page
Loading...
Need help?
General
