TO ACTIVATE THE ACRO MODE
ENTER A NAME FOR THE MODEL
A4
After having selected and reset a model memory, it is time
to tell the TX that the ACRO mode is to be used for this
aircraft.
1. In the SYSTEM Menu, highlight and select Type SEL
using the Selector.
2. Highlight and select ACRO using the Selector.
3. Return to the SYSTEM Menu by pressing
the LIST button.
Each model should be given a name to make it easy
to identify in the model memory list and to identify the
current model on the main display screen. The model
name appears in the upper right hand corner of the main
screen when the transmitter (TX) is switched on.
1. In the SYSTEM Menu, highlight and select MDL
Name using the Selector.
2. The cursor (the little triangle that indicates where the
next character will be placed), is positioned at the
beginning of the model name. Press the Selector to
obtain a list of available characters.
3. Highlight and select the desired character to form the
model name. After the character is selected, rotate
the Selector to position the cursor where the next
character is to be placed and press the Selector to
obtain the character list again. Repeat until the model
name is completed.
4. Return to the SYSTEM Menu by pressing the LIST
button.
To Next Page
Loading...
Need help?
General
