TIMER – TIMER SYSTEM
A46
The XP9303 contains a Timer System that contains two
timers. One is an integrated timer that keeps track of
total time that the TX has been on for the model and
it is displayed on the Main display. The other timer
can be configured as either a Countdown timer or as a
Stopwatch. This timer also appears on the Main display
when active and can be started, stopped and reset from
the Main display. It is a good idea to use the Countdown
timer as a reminder that it is time to land so as not to run
out of fuel.
1. To configure the timer as a Countdown timer highlight
and select Timer in the FUNC.LIST to obtain the
Timer display.
Highlight and select INH under TIMER and then select
DOWN-T. Use the Selector to set the countdown start
time. Once the timer is set, TIM will appear on the Main
display in the lower left corner. Pressing the button next to
TIM on the Main display starts and stops the timer while
pressing the button next to CLR resets the timer to the
programmed value.
2. To Reset the Integrated Timer, highlight and select the
time under INTEG-T and Push[CLR]=0:00 appears
on the display. Press the CLR button to the left of the
display to reset the Integrated timer.
To Next Page
Loading...
Need help?
General
