Table of Contents
Aircraft Section
G3
Introduction ........................................................A-1
Acro Programming-
Please Read ...................................................A-1
Acro - Getting Started –
System Basics Menu ....................................A-1
Access the System Menu ..................................A-2
Select a Model Memory ...................................A-2
Reset the Model .................................................A-3
To Activate the Acro Mode ..............................A-4
Enter a Name for the Model ...........................A-4
Select a Modulation Type ..................................A-5
Acro - System Menu -
Advanced Functions ...............................A-6
Flight Modes ........................................................A-7
To Activate Flight Modes ..............................A-8
Trim:COM (Flight Modes) ................................A-9
D/R:SW (Flight Modes) ....................................A-9
Switch Assignments .........................................A-10
Flap Trim ON/OFF ...........................................A-10
Activate/Inhibit Switches ................................A-11
Wing Type ..........................................................A-12
Wing Parameter – (Wing Type) ....................A-13
V-tail (Wing Type) .............................................A-14
Dual Channels (Wing Type) ...........................A-14
Twin E. (Wing Type) .........................................A-15
Trim Step ............................................................A-16
Acro – Function List ........................................A-17
REV.SW – Servo Reversing ............................A-17
Sub Trim ..............................................................A-18
TRVL ADJ. – Travel Adjust ...............................A-19
D/R & EXP – Dual Rate
and Exponential .........................................A-20
THRO CURV – Throttle Curve ....................A-21
FLAP SYS. – Flap System .................................A-23
Auto Land (Flap System) ................................A-24
ELEV – Elevator Compensation
(Flap System) ..............................................A-25
FLAP – (Flap System) ......................................A-26
FM0-FM2 (Flap System) ..................................A-27
Delay (Flap System) .........................................A-28
ELEFLP M – Elevator-to-Flap
Mising ...........................................................A-29
AILRUD M – Aileron-to-Rudder
Mixing ..........................................................A-30
AIL DIFF. – Aileron Differential .....................A-31
SRV. SPEED – Servo Speed .............................A-33
Snap Roll ............................................................A-34
GYRO SYS. – Gyro System ............................A-35
Gyro Connections (Gyro System) ...............A-35
Fixed Gyro Gain (Gyro System) ...................A-36
Stick Override Gyro Gain
(Gyro System) ............................................A-37
Prog Mix – Programmable Mixers ................A-38
Standard Programmable Mixer –
Example: Down Elevator at Idle .............A-39
MULTI-POINT MIXER – Example: Eliminate
Pitch-Coupling ............................................A-41
Fail Safe ...............................................................A-43
TRAINER – Trainer System ...........................A-44
XP9303 Used as Master (Instructor)
– (Trainer System) .....................................A-44
XP9303 Used as Slave (Student) –
(Trainer System) ........................................A-45
TIMER – Timer System ...................................A-46
Monitor ..............................................................A-47
Utility Functions ...............................................A-48
COPY – Copy the Currently Selected Model
to Another Model Memory .....................A-48
TRANSFER – Transfer the Model to Another
Transmitter or to DataSafe .....................A-50
Receive a Model into the XP9303 –
(Transfer function) .....................................A-50
Sub Trim usage and
Mechanical Advantage ...............................A-52
Sub Trim ..........................................................A-52
Mechanical Advantage .................................A-52
Dual Rates and Exponential Curves ............A-53
To Next Page
Loading...
Need help?
General
