15
ENGLISH
1) Hook S shaped hook
1
and chain
2
supplied with the
machine as accessories in the holes of sections A and
B.
Check that upper roller
3
is not oated in the state that
the foot is kept apart from the pedal.
When it is oated, adjust the length of the chain, and
slightly sag the chain.
2) Adjust the hooking position of the S shaped hook so
that the pedal is placed at the position where the oper-
ator can use it with ease. (Section A :
5
to
7
, Section
B :
8
and
9
)
＊
Lifting amount of the upper feed roller is 14 mm. Adjust
the protruding amount of stopper screw
4
and set the
lifting amount you desire within the range where the
dimension from upper feed roller
3
to lower roller
!0
does not exceed 14 mm.
4. Set-up of the presser foot lifting mechanism
WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and ascertaining that the motor is at rest.
14 mm
B
A
9
8
3
6
7
!0
1
4
2
1
5
To Next Page
Loading...
Need help?
General
