3-8 Installing the operation panel
Fix panel installing plate
2
to the base on the
frame. Install operation panel
1
with a magnet and
pass the cable through the hole in the table.
When the panel is installed in the
state that it is excessively tilted in the
direction A, the work table comes in
contact with the panel and the panel
may be damaged. Install the panel so
that it is not excessively tilted.
3-6 Installing the cover
Slowly tilt the machine head and install bottom cover
1
and bottom feed cover
2
.
3-7 Installing the stopper for tilt prevention
Install stopper plate A
1
and stopper plate B
2
for
tilt prevention.
WARNING :
Whentilting/raisingthesewingmachinehead,performtheworksoasnottoallowyourngersto
be caught in the machine. In addition, to avoid possible accidents caused by abrupt start of the
machine, turn OFF the power to the machine before starting the work.
2
1
2
1
1
2
A
To Next Page
Loading...
Need help?
General
