Jungheinrich ECP 100-3 User Manual

E 15
0803.GB
4.3 Key-operated control of the truck - “Operator walking” (o)
f
When the truck is under key-operated control and the operator walks beside the truck,
he must ensure that the steering unit points straight ahead and that he cannot be
crushed between the truck and other obstacles.
When using this operating mode, the operator must stay beside the truck. There must
not be no-one on the driver stand platform.
The load must be lowered to a free lift of 200 mm.
A
When the truck is under key-operated control, the operator can operate the truck from
either side while walking alongside. The speed is reduced to approx. 2.5 km/h (cut-
back speed).
– Press the “Operator walking / drive direction” key (14, 21). The truck moves at a
permanently set speed of approx. 2.5 km/h (cut-back speed) in travelling direction
(V).
– Press the “Operator walking / fork direction” key (15, 20).
The truck moves at a permanently set speed of approx. 2.5 km/h (cut-back speed) in
travelling direction (R).
f
If the operator leaves the truck in the “Operator walking” mode, the truck must be pro-
tected against inadvertent operation:
– Depress the master switch (emergency stop) (11,19) to the “OFF” position.
16
11
14
15
19
21
20
V
R
V
R
E 15
0803.GB
4.3 Key-operated control of the truck - “Operator walking” (o)
f
When the truck is under key-operated control and the operator walks beside the truck,
he must ensure that the steering unit points straight ahead and that he cannot be
crushed between the truck and other obstacles.
When using this operating mode, the operator must stay beside the truck. There must
not be no-one on the driver stand platform.
The load must be lowered to a free lift of 200 mm.
A
When the truck is under key-operated control, the operator can operate the truck from
either side while walking alongside. The speed is reduced to approx. 2.5 km/h (cut-
back speed).
– Press the “Operator walking / drive direction” key (14, 21). The truck moves at a
permanently set speed of approx. 2.5 km/h (cut-back speed) in travelling direction
(V).
– Press the “Operator walking / fork direction” key (15, 20).
The truck moves at a permanently set speed of approx. 2.5 km/h (cut-back speed) in
travelling direction (R).
f
If the operator leaves the truck in the “Operator walking” mode, the truck must be pro-
tected against inadvertent operation:
– Depress the master switch (emergency stop) (11,19) to the “OFF” position.
16
11
14
15
19
21
20
V
R
V
R

Jungheinrich ECP 100-3 Specifications

General

Brand	Jungheinrich
Model	ECP 100-3
Category	Forklifts
Language	English