Jungheinrich ECP 100-3 User Manual

0803.GB
E 22
5.4 Changing truck parameters
f
Changing truck parameters will also change the driving behaviour of the truck. This
must be taken into account when commissioning the truck!
Parameters may only be changed while the truck is at a standstill and no lifting mo-
vements are performed.
– Start up the truck (refer to section 3).
– Insert the key into the key switch and turn it clockwise to the stop.
First the user menu and the truck designation appear on the display for ca. 3 seconds,
then the current steering angle, the charging state of the battery and the operating
hours are shown.
– Press the selection menu key (43).
The item “Acceleration” is shown on the display along with the pertaining parameter.
– To view or change the truck parameters, proceed as shown in the following dia-
gram.
– Moving between the nine parameters is effected by means of the keys (41)
and (42).
Acceleration
L
1)
Reload
L
1)
Buzzer on/off
L
1)
Cut-back speed for
reversing L
1)
Maximum reversing
speed L
1)
Cut-back speed
forward L
1)
Maximum speed
forward L
1)
Inversion brake
3)
Release brake
L
1)
Acceleration
S
2)
Reload
S
2)
Buzzer on/off
S
2)
Cut-back speed for
reversing
Maximum reversing
speed
Cut-back speed
forward
Maximum speed
forward
Inversion brake
3)
Release brake
yes
Are you
sure?
no
BATT xxx% xx h
1)
L = operating parameters are read out.
2)
S = the selected parameter can be changed using keys and .
3)
no function
0803.GB
E 22
5.4 Changing truck parameters
f
Changing truck parameters will also change the driving behaviour of the truck. This
must be taken into account when commissioning the truck!
Parameters may only be changed while the truck is at a standstill and no lifting mo-
vements are performed.
– Start up the truck (refer to section 3).
– Insert the key into the key switch and turn it clockwise to the stop.
First the user menu and the truck designation appear on the display for ca. 3 seconds,
then the current steering angle, the charging state of the battery and the operating
hours are shown.
– Press the selection menu key (43).
The item “Acceleration” is shown on the display along with the pertaining parameter.
– To view or change the truck parameters, proceed as shown in the following dia-
gram.
– Moving between the nine parameters is effected by means of the keys (41)
and (42).
Acceleration
L
1)
Reload
L
1)
Buzzer on/off
L
1)
Cut-back speed for
reversing L
1)
Maximum reversing
speed L
1)
Cut-back speed
forward L
1)
Maximum speed
forward L
1)
Inversion brake
3)
Release brake
L
1)
Acceleration
S
2)
Reload
S
2)
Buzzer on/off
S
2)
Cut-back speed for
reversing
Maximum reversing
speed
Cut-back speed
forward
Maximum speed
forward
Inversion brake
3)
Release brake
yes
Are you
sure?
no
BATT xxx% xx h
1)
L = operating parameters are read out.
2)
S = the selected parameter can be changed using keys and .
3)
no function

Jungheinrich ECP 100-3 Specifications

General

Brand	Jungheinrich
Model	ECP 100-3
Category	Forklifts
Language	English