To Next Page

To Previous Page

B 1

0201.GB

B Description of the truck

1 Design and application

The truck described in the present operating instructions is a three-wheel vertical

commissioner with a driver stand that can be lifted.

The truck is designed for operation on level ground and is intended for transporting

and commissioning loads. Trolleys and pallets fitted with an open ground support or

with lateral boards can be picked up and commissioned.

As standard, the truck is equipped with a single-stage hoist frame (E hoist frame) or

with a two-stage hoist frame (ZZ hoist frame) (for the lifting heights, see the table be-

low). An auxiliary lifting stage is available as an option, allowing the fork to be lifted

by another 750 mm or 810 mm.

The rated capacity of the truck is shown on the identification plate and on the capacity

label Qmax. The dimensions of the fork are designed according to the type and num-

ber of pallets or trolleys to be picked up.

B 1