To Next Page

To Previous Page

C 1

0201.GB

C Transportation and commissioning

1 Transportation by crane

Only lifting gear of adequate capacity must be used

(transportation weight = dead weight + battery weight; see truck identification plate).

Lifting gear attachment points are

provided on the chassis (2) and the

fork (1) in case the truck is to be lifted

or transported by crane.

– Park the truck and render it safe

(refer to chapter E).

– Secure the lifting gear to the attach-

ment points (1) and (2).

The lifting gear must be attached to

the attachment points in such a man-

ner that it absolutely cannot slip and

cannot come into contact with any at-

tachments of the truck when the truck

is lifted.

2 Commissioning

The truck must only be operated on battery current. Rectified alternate current will da-

mage the electronics. Cables connected to the battery (trailing cables) must be less

than 6 meters in length.

In order to prepare the truck for work following delivery or transportation, the following

operations must be performed:

– Check the truck for completeness and satisfactory condition of the equipment.

– If necessary, install the battery. Do not damage the battery cable.

(Refer to chapter D)

– Charge the battery (refer to chapter D).

– If necessary, check whether the setting shown on the information and service dis-

play matches the type of battery (refer to chapter D).

– Start up the truck as prescribed (refer to chapter E).

When the truck is parked, the running surface of the tyres will flatten. The flattening

will disappear after a short operating time of the truck.

C 1