189
11.14 EN
4.15 Cleaning
CAUTION!
Fire hazard
The truck must not be cleaned with flammable fluids.
If flammable materials are not removed from the engine compartment, they can come
into contact with hot components and cause a fire.
X
Carry out all necessary safety measures to prevent sparking before cleaning (e.g.
by short-circuiting).
X
Remove all deposits / accumulations of flammable materials from the engine
compartment.
CAUTION!
Risk of component damage when cleaning the truck
Cleaning with a pressure washer can result in malfunctions due to humidity.
X
Cover all electronic system assemblies (controllers, sensors, motors etc.) before
cleaning the truck with a pressure washer.
X
Do not hold the jet of the pressure washer by the marked points to avoid damaging
them (see "Preparing the truck for maintenance and repairs" on page 162).
XDo not clean the truck with pressurised water.
Cleaning the truck
Requirements
– Prepare the truck for maintenance and repairs (see "Restoring the truck to service
after decommissioning" on page 196).
Tools and Material Required
– Water-based solvents
– Sponge or cloth
Procedure
• Clean the surface of the truck with water-based solvents and water. Use a sponge
or cloth to clean.
• In particular, clean the following areas:
• Windows
• All walk-on areas
• Oil filler ports and their surroundings
• Grease nipples (before lubrication)
• Dry the truck after cleaning, e.g. with compressed air or a dry cloth.
• Carry out all the tasks in the section "Recommissioning the truck after cleaning or
maintenance work" (see "Preparing the truck for maintenance and repairs" on
page 162).
The truck is now clean.
To Next Page
Loading...
Need help?
General
