203
11.14 EN
10.2 Customer Service
10.2.1 Standard Equipment
Brakes W A B C
1 Test brakes. t
2 Check the brake lining on the parking brake. t
3 Check connections and lines for leaks. t
Electrical System W A B C
1
Test warning and safety devices in accordance with operating
instructions.
t
2 Test displays and controls. t
3 Test the main switch / battery isolator. t
4 Test Emergency Disconnect switch. t
5 Check contactors and/or relays. t
6 Check fuse ratings. t
7
Check electrical wiring for damage (insulation damage,
connections). Make sure wire connections are secure.
t
Power supply WABC
1 Check fuel system, tank and lines for leaks and damage. t
2
Check battery cable connections are secure, grease terminals if
necessary.
t
3 Check battery and battery components. t
4 Check battery voltage. t
Travel W A B C
1 Replace transmission oil filter. t
2
Check transmission oil level or grease filling of the transmission and
top up if necessary.
t
3 Replace the axle return filter. t
4 Test exhaust system and check for leaks and damage. t
5 Test anti-freeze, top up if necessary. t
6 Replace radiator fluid and anti-freeze. t
7 Check cooling system for leaks. t
8 Check coolant level and top up if necessary. t
9 Test hydraulic fans and check for leaks. t
10 Clean the engine oil cooler. t
11 Check and clean radiator. t
12 Check transmission for noise and leakage. t
13 Replace transmission oil. t
14 Check tyre air pressure and top up if necessary. t