47
11.14 EN
4 Using the Truck for the First Time
Safety Instructions for Assembly and Commissioning
WARNING!
Incorrect assembly can result in accidents
The assembly of the truck at the application site, commissioning and operator training
must only be performed by the manufacturer's customer service representatives who
have been specially trained for these tasks.
X
The hydraulic lines may only be connected to the basic truck / mast interface when
the mast has been properly assembled.
X
Only then can the truck be started.
X
If several trucks have been delivered, make sure that the serial numbers of the load
handlers, masts and basic trucks always match.
Preparing the truck for operation after delivery or transport
Procedure
• Check the equipment is complete.
• Check the engine oil level.
• Check the hydraulic oil level.
• Check the transmission oil level.
• Check the brake fluid level.
• Test the battery connections.
• Check the battery acid level (not for maintenance-free batteries).
The truck can now be started, see "Preparing the Truck for Operation" on page 86.
To Next Page
Loading...
Need help?
General
