21
PRODUCT DESCRIPTION
2 Product Description
The drive converter series COMBIVERT S6 is optimized for the operation at synchro-
nous and asynchronous motors. The integrated safety function STO has been devel-
oped for the use in safety-oriented applications.
The COMBIVERT meets the requirements of the Low-Voltage Directive. The harmo-
nized standards of the series EN 61800-5-1 for drive converters were used.
The COMBIVERT is a product of limited availability in accordance with EN 61800-3. This
product may cause radio interference in residential areas. In this case the operator may
need to take corresponding measures.
The machine directive, EMC directive, Low Voltage Directive and other guidelines and
regulations must be observed depending on the version.
2.1 Specied application
The COMBIVERT serves exclusively for the control and regulation of three-phase mo-
tors. It is intended for the installation into electrical systems or machines.
Technical data and information for connection conditions shall be taken from the type
plate and from the instruction manual and must be strictly observed.
The used semiconductors and components of the KEB Automation KG are developed
and dimensioned for the use in industrial products.
Restriction
If the KEB COMBIVERT F5 is used in machines, which work under exceptional condi-
tions or if essential functions, life-supporting measures or an extraordinary safety step
mustbefullled,thenecessaryreliabilityandsecuritymustbeensuredbythemachine
builder.
2.1.1 Residual risks
Despite intended use, the drive converter can reach unexpected operating conditions in
case of error, with wrong parameterization, by faulty connection or unprofessional inter-
ventions and repairs. This can be:
• wrong direction of rotation
• motor speed too high
• motor is running into limitation
• motor can be under voltage even in standstill
• automatic start
2.2 Unintended use
The operation of other electric consumers is prohibited and can lead to the destruction of
the unit. The operation of our products outside the indicated limit values of the technical
data leads to the loss of any liability claims.
To Next Page
Loading...
Need help?
General
