Keithley 2430 User Manual

2-8 Calibration
2. Press the MENU key, then choose CAL and press ENTER. Select UNLOCK, and then
press ENTER. The instrument will display the following:
PASSWORD:
Use
ß
,
©
,
¹
,
ƒ
, ENTER or EXIT.
3. Use the up and down range keys to select the letter or number, and use the left and right
arrow keys to choose the position. Enter the present password on the display. (Front
panel default: 002430.) Press ENTER to complete the process.
4. Press EXIT to return to normal display. Instrument operating states will be set as sum-
marized in Table 2-2.
Step 2: Voltage calibration
Perform the steps below for each voltage range, using Table 2-3 as a guide.
1. Connect the Model 2430 to the digital multimeter, as shown in Figure 2-1. Select the
multimeter DC volts measurement function.
Model 2430
Digital Multimeter
Input HI
Input LO
2430 1KW PULSE SourceMeter
250V
PEAK
5V
PEAK
HI
LO
OUTPUT
125V
PEAK
125V
PEAK
EDIT
TOGGLE
POWER
RANGE
INPUT/
OUTPUT
4- WIRE
SENSE
DISPLAY
ON/OFF
TERMINALS
FRONT/
REAR
AUTO
RANGE
!
®
EXIT ENTER
CONFIG MENU
SWEEP
TRIG
REL
LOCAL
FILTER
LIMIT
DIGITS SPEED
V
Ω
MEAS
I
FCTN
V
I
SOURCE
230
1
67
89
4
+/-
5
STORE
RECALL
EDIT
Figure 2-1
Voltage calibration
test connections
2. From normal display, press the SOURCE V key.
3. Press the EDIT key to select the source field (cursor flashing in source display field), and
then use the down RANGE key to select the 200mV source range.
4. From normal display, press MENU.
5. Select CAL, then press ENTER. The unit will display the following:
CALIBRATION
UNLOCK EXECUTE VIEW-DATES
©
ß
SAVE LOCK CHANGE-PASSWORD
6. Select EXECUTE, then press ENTER. The instrument will display the following
message:
V-CAL
Press ENTER to Output +200.00mV

Keithley 2430 Specifications

General

Brand	Keithley
Model	2430
Category	Measuring Instruments
Language	English